angular positions造句
例句與造句
- angular position sensor
角度位置傳感器 - error analysis on getting inertial angular position with linear accelerometers is improved
改進了對線加速度計測量慣性姿態角的誤差分析。 - theory of getting inertial angular position from linear accelerometer measurements with double integration algorithm is analyzed
分析了使用線加速度計測量慣性角加速度,通過二次積分算法得到慣性姿態角的原理。 - the balancing process, then, involves determining the number of gram-centimeters to be compensated for, and locating the proper angular position at which to add such compensation
厘米）加在轉子固有不平衡量的相反位置上，故平衡的過程涉及不平衡量大小的補償值的決定，及補償值的正確定位。 - disengage in unprecedented 2 to 4 msecs of an overload signal, compared to conventional couplings that take a full second to disengage . ours automatically re-engage at the precise angular position
接到過載信號后，2-4毫秒斷開。并且以精確的角度自動重新連接。這個時間是無法比擬的。常規聯軸器需要1秒時間。 - It's difficult to find angular positions in a sentence. 用angular positions造句挺難的
- to restore balance, that same number of gram-centimeters must be added to the assembly 180 degrees away . the balancing process, then, involves determining the number of gram-centimeters to be compensated for, and locating the proper angular position at which to add such compensation
恢復平衡需要將一定數量的不平衡量(克?厘米)加在轉子固有不平衡量的相反位置上，故平衡的過程涉及不平衡量大小的補償值的決定，及補償值的正確定位。 - this paper puts emphasis on dynamic simulation based on switched reluctance drivers's ( srd's ) nonlinear model, and study of fuzzy control for srd . based on switched reluctance motor's linear, nonlinear model, the dynamic simulation model of srd's is built respectively . the phase current, phase torque, total torque and speed of srm in current chopping control ( ccc ) and angular position control ( apc ) are calculated respectively with this simulation
本文在分析sr電機線性、準線性、非線性模型的基礎上建立了四相(8/6極)sr電機調速系統(srd)動態線性、非線性仿真模型，分別對電流斬波控制方式(ccc)與角度位置控制方式(apc)下sr電機相電流、一相轉矩、合成轉矩及角速度進行了仿真。 - two nonlinear simulation methods are designed by curve fitting method and anfis which seem simply and right in the simulation experiment . based on the model different control strategies also were realized in detail such as chopped current control ( ccc ), angular position control ( apc ), amplitude-change ccc and pi control . a simple torque sharing function ( tsf ) method and a tsf controller were designed which decreases torque ripple effectively
文章中還建立一種基于模糊神經網絡的非線性模型,并對比分析了三種方法,仿真中確定了電機的最優開通關斷角,在此基礎上實現了電流斬波控制、角度位置控制、變幅值電流斬波控制以及分段雙閉環pi控制,仿真結果表明,它實現了電機的正常運行,很好的抑止了電機轉矩脈動,同時有效地降低了噪聲。